Whirlpool Refrigerator WRS571CIHZ: EveryDrop Filter... | appliancefaults.com

Technical Background:

The refrigerator's water system directs water through the filter housing to provide filtered water to the dispenser and ice maker. The MCU monitors water flow and pressure. If there is a leak, it can trigger error codes on some models, but a simple leak won't trip the MCU.

Symptoms:

The homeowner observes water leaking from the EveryDrop™ water filter housing inside the refrigerator.

Possible Causes:

Cracked filter housing
Damaged O-rings or seals
Improper filter system
Excessive water pressure
Loose filter head connection

Solution:

1

Turn off the water supply to the refrigerator. Locate the shut-off valve, usually under the sink or behind the refrigerator. Close the valve completely.
2

Remove the EveryDrop™ water filter. Refer to the owner's manual for the correct removal procedure.
3

Inspect the filter housing for cracks or damage. If cracked, replace the entire housing assembly.
4

Examine the O-rings and seals on the filter head and filter. Replace any damaged or worn O-rings with new ones.
5

Ensure the filter is properly installed. Align the filter correctly and twist until it locks into place.
6

Check the water pressure entering the refrigerator. It should be between 30 and 100 PSI. Install a pressure regulator if needed.
7

Tighten the connections between the water lines and the filter head. Use a 7/16-inch wrench to gently tighten the fittings. Be careful not to overtighten.

Safety Warning:

Disconnect the refrigerator from the breaker panel before performing any repairs. Water and electricity can create a shock hazard. Wear safety glasses.

Prevention:

Replace the EveryDrop™ water filter every 6 months, or as recommended by the manufacturer. This helps prevent clogs and maintains proper water flow. Inspect the filter housing and O-rings during filter replacement. Ensure correct filter system.

Expert Tip:

Apply a thin coat of food-grade silicone grease to the O-rings before installing the new filter. This helps create a better seal and prevents leaks. Check service flash updates.

Frequently Asked Questions

•What is the part number for a replacement filter housing assembly on the WRS571CIHZ?

The part number can vary depending on the exact model series. Check the appliance's parts diagram or the Whirlpool website with your specific model number for the correct part.

•How do I test the water pressure going into the refrigerator?

Use a water pressure gauge. You can purchase one at most hardware stores. Connect the gauge to the water supply line feeding the refrigerator after turning off the water supply. Then turn the water back on to read the pressure.

•What type of food-grade silicone grease should I use?

Use a silicone grease specifically labeled as 'food-grade' or ' NSF certified'. This ensures it is safe for contact with potable water.

Whirlpool Refrigerator WRS571CIHZ: EveryDrop Filter Housing Leaking - Troubleshooting Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•What is the part number for a replacement filter housing assembly on the WRS571CIHZ?

•How do I test the water pressure going into the refrigerator?

•What type of food-grade silicone grease should I use?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: