Frequently Asked Questions
•How do I access the drain pump on my Roper washing machine?
The drain pump is usually located behind a small access panel at the bottom front of the washing machine. You'll typically need a flathead screwdriver to remove the panel. Be prepared for some water to spill out, so have a towel handy.
•What resistance readings should I expect when testing the motor windings?
The resistance values will vary depending on the specific motor. However, you should expect to see a low resistance (typically a few ohms) between each winding terminal. An open circuit (infinite resistance) or a short circuit (zero resistance) indicates a faulty winding.
•How do I clear the F0E3 error code after fixing the problem?
Some Roper washers will automatically clear the code after the fault is resolved. If not, try unplugging the machine for several minutes, then plugging it back in. As a last resort, attempting to clear the code using the service mode (if available) may be necessary.