Frequently Asked Questions
•How do I know if my pressure switch is bad?
You can test the pressure switch for continuity using a multimeter. With the washer empty, check for continuity across the appropriate terminals. Then, gently blow into the pressure switch port and check for a change in continuity. If the continuity doesn't change, the switch is likely faulty.
•Where is the drain pump filter located on my Roper washer?
The drain pump filter is typically located at the bottom front of the washer, behind a small access panel. You may need a flathead screwdriver to open the panel. Be prepared for some water to spill out when you remove the filter.
•How much HE detergent should I use in my Roper washer?
The amount of HE detergent to use depends on the size of the load and the level of soil. Consult the detergent manufacturer's recommendations on the detergent packaging. Generally, you'll use a much smaller amount of HE detergent than regular detergent.