GE Profile Washer E60 Error Code: Door Lock... | appliancefaults.com

Technical Background:

The E60 error code on a GE Profile washer indicates a communication fault between the main control unit (MCU) and the door lock assembly. The MCU sends a signal to the door lock to engage, and expects a confirmation signal back. If this communication is disrupted, the E60 error appears. Voltage is supplied to the door lock mechanism to engage the locking solenoid.

Symptoms:

Homeowner reports the washer displays an E60 error code and will not start. The door may or may not appear to be locked. The wash cycle will not initiate.

Possible Causes:

Faulty door lock assembly
Wiring harness issue between the main control board and door lock
Defective main control board (MCU)
Loose wire connections
Damaged door switch
Obstruction preventing the door from properly latching

Solution:

1

Disconnect power to the washer at the breaker panel.
2

Inspect the wiring harness connecting the door lock assembly to the main control board for any damage or loose connections.
3

Using a multimeter, check the voltage at the door lock connector. You should see approximately 120V AC when the door is supposed to be locked.
4

Remove the door lock assembly using a 1/4-inch nut driver and test the door switch with a multimeter for continuity when the door is closed. Replace the door lock assembly if the switch is faulty.
5

If the wiring and door lock assembly are good, the main control board may be defective. Replace the main control board.
6

After replacing the door lock or MCU, run a diagnostic cycle to confirm the E60 error is cleared.
7

Ensure proper door alignment for smooth operation.

Safety Warning:

Always disconnect power to the appliance at the breaker panel before performing any repairs. Lock Out/Tag Out (LOTO) procedures are critical to avoid electrical shock. The washer operates on 120V AC.

Prevention:

• Avoid slamming the washer door.
• Regularly inspect the door seal for damage.
• Ensure the washer is level to prevent excessive vibration.

Expert Tip:

To access the service mode, press and hold the Start/Pause and Signal buttons simultaneously for 3 seconds. This will allow you to run diagnostic tests and clear error codes.

Follow-up Questions:

Frequently Asked Questions

•How do I test the door lock assembly with a multimeter?

Set your multimeter to the continuity setting (ohm symbol). With the door closed (simulating a locked state), place the multimeter probes on the appropriate terminals of the door switch. You should hear a beep or see a reading close to zero ohms, indicating continuity. If there is no continuity, the switch is faulty.

•Where is the main control board located?

The main control board is typically located behind the control panel. You will need to remove the control panel to access it. Be careful when disconnecting the wiring harnesses from the board.

•What is the part number for the door lock assembly for my specific GE Profile washer model?

To determine the correct part number for your specific model, you will need to locate the model number of your washer (usually found on a sticker inside the door or on the back of the unit). Then, search for the part number online using your model number and "door lock assembly" or consult a parts supplier.

GE Profile Washer E60 Error Code: Door Lock Communication Fault Repair

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I test the door lock assembly with a multimeter?

•Where is the main control board located?

•What is the part number for the door lock assembly for my specific GE Profile washer model?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: