Frigidaire Gallery French Door Refrigerator Ice Maker... | appliancefaults.com

Technical Background:

The ice maker operation is controlled by the main control unit (MCU). The MCU receives input from the thermistor and the water inlet valve switch. It then energizes the ice maker motor and the water inlet valve based on pre-programmed logic and temperature thresholds. The voltage path includes 120V AC to the water inlet valve and a lower voltage DC signal to the ice maker motor.

Symptoms:

The homeowner reports the ice maker is making a loud clicking noise but is not producing ice. The refrigerator is a Frigidaire Gallery French Door model.

Possible Causes:

Faulty ice maker motor
Water supply issue (low pressure or clogged line)
Defective water inlet valve
Ice maker thermistor malfunction
Frozen ice maker assembly
Control board failure

Solution:

1

Disconnect power to the refrigerator at the breaker panel. Verify 0V AC at the wall receptacle with a multimeter.
2

Locate the ice maker assembly. Remove the ice maker cover using a 1/4-inch nut driver.
3

Inspect the ice maker for ice buildup. If frozen, use a hair dryer on low heat to carefully thaw the ice.
4

Check the water inlet valve. Ensure the water line is not kinked or frozen. Measure water pressure (should be above 20 PSI).
5

Test the water inlet valve solenoid for continuity using a multimeter. If no continuity, replace the valve.
6

Manually cycle the ice maker using the test switch. Observe the motor operation. If the motor clicks but does not turn, replace the ice maker assembly.
7

If the issue persists, check the thermistor resistance at the control board. Compare the reading to the service manual chart. If out of range, replace the thermistor.

Safety Warning:

Always disconnect power to the appliance before performing any repairs. Use proper Lock-Out/Tag-Out (LOTO) procedures. High voltage is present in the control panel and water inlet valve area.

Prevention:

Replace the refrigerator water filter every 6 months. Periodically inspect the water line for kinks or damage. Clean the ice maker assembly with a mild detergent solution every year.

Expert Tip:

To force a defrost cycle, simultaneously press and hold the 'Up' and 'Down' buttons on the refrigerator control panel for 5 seconds. This may help melt any hidden ice buildup.

Frequently Asked Questions

•What is the correct resistance value for the thermistor at 32 degrees Fahrenheit?

Refer to the service manual for your specific Frigidaire Gallery model. Thermistor resistance values vary by model and temperature. Generally, it should be around 5-10k ohms at 32F.

•How do I access the service mode on this Frigidaire Gallery model?

Accessing the service mode varies between models. Typically, it involves a specific sequence of button presses, often holding two buttons simultaneously for a few seconds. Consult the technical service documentation for the precise steps for your model.

•What type of water line is recommended for replacing the existing line to the refrigerator?

Use a 1/4-inch OD (Outside Diameter) NSF-certified polyethylene or braided stainless steel water line specifically designed for refrigerators. Avoid using copper tubing, as it can impart a metallic taste to the water and ice.

Frigidaire Gallery French Door Refrigerator Ice Maker Clicking, No Ice: Troubleshooting

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•What is the correct resistance value for the thermistor at 32 degrees Fahrenheit?

•How do I access the service mode on this Frigidaire Gallery model?

•What type of water line is recommended for replacing the existing line to the refrigerator?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: