Frequently Asked Questions
•What is the resistance value I should expect from a working moisture sensor?
A working moisture sensor's resistance varies based on humidity. When wet, resistance should be near zero ohms. When dry, resistance should be very high, typically several megaohms. Check the technical service manual for your model for specific values.
•How do I access the control board in my Whirlpool dryer?
Accessing the control board usually involves removing the top panel or the rear panel of the dryer. Refer to your dryer's service manual for detailed disassembly instructions. Typically this will involve a 1/4 inch nut driver or a Phillips head screwdriver.
•Where is the thermistor located in my Whirlpool dryer, and how do I test it?
The thermistor is typically located on the blower housing or near the heating element. To test it, disconnect power and use a multimeter to measure the resistance across its terminals. A typical reading at room temperature (70-75°F) is around 10k ohms. Refer to your model's service manual for accurate location and specifications.