Frequently Asked Questions
•How do I determine if my pressure switch is faulty?
A faulty pressure switch can be tested using a multimeter to check for continuity. Disconnect the power and the switch. Then, use the multimeter to test continuity between the terminals with the tub empty and full. If the readings don't change or there's no continuity when there should be, the switch is likely defective.
•Where is the drain pump filter located on my Roper washer?
The drain pump filter is usually located at the front bottom of the washer, behind a small access panel. You may need a flathead screwdriver to open the panel. Always place a towel underneath to catch any spilled water.
•What does HE detergent mean, and why is it important?
HE stands for High Efficiency. HE detergents are designed to produce fewer suds, which is crucial for modern washers that use less water. Using non-HE detergent can lead to excessive suds, causing error codes and potential damage to the washer.