Frequently Asked Questions
•How do I access the drain pump on my Roper washer model?
Typically, you'll need to unplug the washer, then remove the lower front access panel. This panel is usually held in place by screws or spring clips. Once removed, the drain pump should be visible and accessible.
•Where is the pressure switch located, and how do I test it?
The pressure switch is typically located at the top of the washer cabinet, near the control panel. It will have a small hose connected to it that runs down to the tub. To test it, disconnect the hose and use a multimeter to check for continuity. The resistance should change as you gently blow into the switch.
•If the drain pump is clear, what else could be preventing the washer from draining?
If the drain pump is clear, check the drain hose for kinks or clogs. Also, ensure that the standpipe into which the drain hose empties is not clogged. A restricted standpipe can prevent the washer from draining properly.