Roper Washer: Clothes Still Wet After Spin Cycle -... | appliancefaults.com

Technical Background:

The washer's Main Control Unit (MCU) relies on feedback from the water level pressure switch and lid switch to initiate and control the spin cycle. Voltage (typically 5V DC) is sent to these switches, and the returned signal determines the next action. The motor control board receives commands from the MCU to power the motor for spinning.

Symptoms:

The Roper washer completes the wash cycle, but clothes are still excessively wet after the spin cycle, even after a repair attempt.

Possible Causes:

Clogged drain pump or drain hose.
Worn or loose drive belt (if applicable).
Defective lid switch or lid lock.
Faulty motor or motor control board.
Blocked air vent causing siphoning.
Malfunctioning water level pressure switch.

Solution:

1

Unplug the washer from the 120V AC outlet.
2

Check the drain hose for kinks or clogs. Disconnect the hose and flush it out.
3

Inspect the drain pump for obstructions. Remove any debris found.
4

Verify the lid switch or lid lock is functioning correctly using a multimeter. It should show continuity when the lid is closed.
5

If the washer has a drive belt, inspect it for wear or looseness. Replace if necessary.
6

Use a multimeter to check the motor windings for continuity. Consult the wiring diagram for correct values.
7

Inspect the air vent; it is often located by the drain hose connection and may be blocked with lint.

Safety Warning:

Disconnect power to the appliance at the breaker panel before attempting any repairs. Capacitors in the motor control board can store a dangerous electrical charge even after the power is disconnected. Use extreme caution when working around electrical components.

Prevention:

Regularly clean the lint filter and inspect the drain hose for kinks or clogs. Avoid overloading the washer. Periodically run an empty washer cycle with a washing machine cleaner.

Expert Tip:

Many Roper washers have a diagnostic mode. Consult the service manual to initiate the diagnostic mode and retrieve error codes that may pinpoint the problem. A common method involves rapidly turning the cycle selector knob in a specific sequence.

Frequently Asked Questions

•What are the typical multimeter readings for a healthy motor?

A healthy motor should have a low resistance (typically a few ohms) between its windings. Consult the specific model's wiring diagram for exact values.

•How do I access the drain pump on my Roper washer?

The drain pump is usually located behind an access panel at the bottom front of the washer. You may need a 1/4-inch nut driver or a Phillips head screwdriver to remove the panel.

•Where can I find the wiring diagram for my specific Roper washer model?

The wiring diagram is often located inside the washer cabinet, either on the back panel or behind the control panel. You can also search online using the model number of your washer.

Roper Washer: Clothes Still Wet After Spin Cycle - Troubleshooting

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•What are the typical multimeter readings for a healthy motor?

•How do I access the drain pump on my Roper washer?

•Where can I find the wiring diagram for my specific Roper washer model?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: