Roper Range Gas Burner Clicks When Off: Troubleshooting... | appliancefaults.com

Technical Background:

The Roper range uses a spark ignition system. When a burner knob is turned on, the ignition switch signals the spark module to generate a high-voltage spark at the burner. The spark module receives 120V AC power and the signal to ignite. A faulty spark module, a short in the wiring, or a problem with the ignition switch can cause continuous sparking.

Symptoms:

The Roper gas range burner igniter clicks continuously even when the burner control knob is in the 'off' position. This clicking continues indefinitely until the range is unplugged or the breaker is switched off.

Possible Causes:

Faulty spark module
Shorted ignition switch
Stuck relay on the control board
Moisture or debris around the burner assembly
Wiring harness issue

Solution:

1

Disconnect power to the range at the breaker panel.
2

Remove the range top. Typically this involves removing screws from the back and lifting.
3

Inspect the burner assembly for any visible debris or moisture. Clean with a dry cloth.
4

Locate the spark module (igniter control module). It's often a small rectangular box.
5

Disconnect the wires from the spark module and test the module for continuity using a multimeter. A short circuit indicates a faulty module. Replace if needed.
6

If the spark module tests good, check the ignition switch (behind the burner knob) for continuity in the 'off' position. If there's continuity when 'off', replace the ignition switch.
7

If both components test good, the issue may be with the main control board. Replacing the control board is often the last resort.

Safety Warning:

Disconnect power at the breaker panel before working on the range. Gas appliances involve potentially dangerous voltages and flammable gas. Lock Out/Tag Out (LOTO) procedures should be followed. Exercise caution when working with 120V AC.

Prevention:

Regularly clean the burner assembly to prevent debris and moisture buildup. Annually inspect the wiring harness for damage.

Expert Tip:

Some Roper ranges have a service mode. Consult the service manual for accessing this mode, as it might provide diagnostic codes to pinpoint the faulty component. Unfortunately, without the model number, I cannot provide those instructions.

Frequently Asked Questions

•How do I identify the spark module on my range?

The spark module is usually a small, rectangular or square-shaped box, often made of plastic or metal. It typically has multiple wires connected to it. It is usually located near the burner area or behind the control panel.

•What type of multimeter settings should I use when testing for continuity?

Set your multimeter to the continuity setting (often indicated by a diode symbol or a sound wave symbol). When testing, the meter should beep or display a low resistance value (close to 0 ohms) if there is continuity.

•How do I remove the burner knobs on my Roper range?

Most Roper range burner knobs can be pulled straight off. Some may have a small screw on the side that needs to be loosened first using a small flat-head screwdriver before pulling the knob off. Never force the knob off.

Roper Range Gas Burner Clicks When Off: Troubleshooting Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I identify the spark module on my range?

•What type of multimeter settings should I use when testing for continuity?

•How do I remove the burner knobs on my Roper range?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: