Frequently Asked Questions
•Where is the lint screen sensor located on my Roper dryer?
The lint screen sensor is typically located inside the lint screen housing, either at the bottom or on one of the sides. It might be a small metal contact or an optical sensor.
•How do I access the main control board (MCU) on my Roper dryer?
The location and access procedure for the MCU vary depending on the specific Roper dryer model. Consult the service manual for your dryer model. Generally, you'll need to remove the dryer's top panel or rear panel to access the MCU.
•What voltage should I expect to see at the lint screen sensor wiring on the main control board?
Typically, the lint screen sensor circuit on the main control board operates on a low voltage, such as 5V DC. Refer to the wiring diagram for your specific Roper dryer model for the exact voltage reading.