Frequently Asked Questions
•How do I test the ice maker water inlet valve with a multimeter?
Disconnect the valve's electrical connector. Set your multimeter to the ohms setting (resistance). Place the multimeter probes on the valve's terminals. A reading of infinity or OL (open loop) indicates a faulty valve that needs replacement. A typical reading for a functional valve is between 200-500 ohms.
•Where is the water filter located on my Hotpoint refrigerator, and how do I replace it?
The water filter location varies depending on the model. Common locations are inside the refrigerator compartment (usually top right), in the base grille, or at the back of the refrigerator. To replace, locate the filter housing, twist or push to release the old filter, and insert the new filter, following the manufacturer's instructions. Run several gallons of water through the dispenser to flush out any air or debris.
•What is the correct fill time for the ice maker, and how can I measure it?
The fill time varies based on the model, but it's generally between 5-10 seconds. You can observe the ice maker during its cycle after reconnecting power. Use a stopwatch to time how long the water valve is energized and dispensing water into the ice mold. If the fill time significantly exceeds the normal range, it could indicate a faulty valve or MCU.