Frequently Asked Questions
•How do I test the blower motor for proper function?
Disconnect the power and access the blower motor. Check for any obstructions preventing the blower wheel from spinning freely. Use a multimeter to check the motor windings for continuity. If the windings are open or shorted, the motor needs to be replaced. You can also check the voltage supplied to the motor when the dryer is running; it should be approximately 120V AC.
•What is the proper length and material for the dryer vent duct?
The dryer vent duct should be as short and straight as possible, ideally less than 25 feet in total length, accounting for bends (each 90-degree bend subtracts approximately 5 feet from the maximum length). Use rigid metal ductwork; avoid flexible plastic or foil ducts, as they are fire hazards and restrict airflow.
•Where is the best place to find a wiring diagram for my Hotpoint dryer model?
A wiring diagram is usually located inside the dryer, often attached to the inside of the rear access panel or control panel. You can also search online using the model number, or contact a Hotpoint authorized service center for assistance in obtaining the correct diagram. Always verify that the diagram matches your specific model number.