Frequently Asked Questions
•What is the typical resistance range for a Hotpoint dryer thermistor at room temperature (70°F)?
A typical resistance range for a Hotpoint dryer thermistor at 70°F is approximately 10k to 12k ohms. However, always consult the dryer's service manual for the specific value for your model.
•How do I access the heating element in a Hotpoint dryer to test it for continuity?
Typically, you will need to remove the rear access panel of the dryer. Disconnect the power before removing the panel. The heating element is usually located within a metal housing. Disconnect the wires from the element and then test for continuity using a multimeter.
•What size socket or nut driver is typically needed to remove the blower housing in a Hotpoint dryer?
A 5/16-inch nut driver or socket is commonly used to remove the screws securing the blower housing in many Hotpoint dryer models. However, it's always best to visually inspect the fasteners before starting and use the correct size tool.