Frequently Asked Questions
•How do I access the drain pump on my GE dishwasher?
Typically, you can access the drain pump by removing the lower access panel (kick plate) on the front of the dishwasher. You may need to remove a few screws. Once the panel is off, the drain pump is usually located at the bottom right or left corner. Disconnect the wiring and the drain hose before removing the pump. It may be held in place by a locking ring or screws.
•What is the typical resistance reading for a good drain pump?
The resistance of a good drain pump motor typically ranges from 5 to 15 ohms. Use a multimeter to measure the resistance across the pump's terminals. An open circuit (infinite resistance) or a very low resistance indicates a faulty pump.
•Where is the pressure switch located and how do I test it?
The pressure switch is typically located near the bottom of the dishwasher tub, often accessible from the inside. It's a small, round component with wires connected to it. To test it, disconnect the power, remove the wires, and use a multimeter to check continuity. The switch should be open (no continuity) when the tub is empty and closed (continuity) when the tub is full of water. You may need to manually actuate the switch to simulate water pressure.