Frequently Asked Questions
•How do I test the water inlet valve with a multimeter?
Disconnect power to the washer. Remove the wires connected to the water inlet valve terminals. Set your multimeter to ohms (resistance). Place the probes on the valve terminals. You should read a resistance value (typically between 500-1500 ohms). An open circuit (no reading) indicates a faulty valve. Also, test for continuity between each terminal and the valve body. There should be no continuity, indicating no short to ground.
•Where is the pressure switch located and how can I access it?
The pressure switch is typically located near the bottom of the washer cabinet or near the top of the outer tub. Access varies by model but usually involves removing the top panel or a side panel. Refer to the service manual or a repair video for your specific model for detailed instructions.
•What type of water inlet valve does my Frigidaire washer use?
Frigidaire washers typically use either a single or dual water inlet valve. The type depends on whether the washer uses cold water only or both hot and cold water for washing. The part number can be found on the valve itself or by looking up your model number on a parts website such as AppliancePartsPros or RepairClinic.