Frigidaire Washer Drum Hitting Cabinet During Low Speed... | appliancefaults.com

Technical Background:

The Main Control Unit (MCU) controls the motor speed during the spin cycle. The MCU relies on feedback from the motor speed sensor to adjust the motor's voltage. Suspension components are designed to dampen vibrations and keep the drum centered. Voltage paths to the motor and drain pump need to be verified.

Symptoms:

The washing machine drum bangs against the cabinet, particularly during the initial low-speed spin cycle. The machine may also vibrate excessively.

Possible Causes:

Worn suspension rods.
Weakened or broken tub dampening straps.
Unbalanced load inside the washer drum.
Damaged or worn snubber ring (friction ring).
Loose motor mounting bolts.

Solution:

1

Disconnect the washer from the outlet and shut off the water supply valves.
2

Remove the top panel. Typically, this involves removing screws at the rear of the machine with a 1/4-inch nut driver and sliding the panel back.
3

Carefully inspect the suspension rods, located at each corner of the tub. Replace any rods that show signs of wear or are broken.
4

Check the tub dampening straps (if equipped) for any damage or detachment. Replace as needed.
5

Inspect the snubber ring (friction ring) at the base of the tub for wear or damage. Replacing this requires tub disassembly.
6

Ensure the motor mounting bolts are tightened using a 1/2-inch socket wrench.
7

Reassemble the washer and level the machine using a level tool.

Safety Warning:

Disconnect power (LOTO - Lock Out Tag Out) before servicing. High voltage components are present. Verify capacitor discharge before touching any components.

Prevention:

Avoid overloading the washer. Distribute clothes evenly in the drum. Periodically inspect suspension components for wear.

Expert Tip:

Enter service mode by pressing and holding the Start/Pause button and then pressing the Power button. Use the cycle selector knob to navigate diagnostic tests.

Follow-up Questions:

Frequently Asked Questions

•How do I determine if my suspension rods are worn out?

Visually inspect for signs of wear, such as rust, cracks, or excessive play. Compare the resistance of each rod by hand; worn rods will feel weaker.

•What is the correct way to balance a load in the washing machine?

Distribute clothes evenly around the agitator or impeller. Avoid washing single heavy items like blankets alone. Add smaller items to balance the load.

•Where can I find replacement parts for my Frigidaire washer?

Genuine Frigidaire parts can be purchased from appliance parts retailers online or from local appliance repair shops. Ensure you have your model number handy.

Frigidaire Washer Drum Hitting Cabinet During Low Speed Spin: How to Fix

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I determine if my suspension rods are worn out?

•What is the correct way to balance a load in the washing machine?

•Where can I find replacement parts for my Frigidaire washer?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: