Frigidaire Stove Top Burner Clicking When Off:... | appliancefaults.com

Technical Background:

The Frigidaire range uses an electronic ignition system. The burner switch controls the flow of 120V AC to the spark module. The spark module then generates a high-voltage spark to ignite the gas. The electronic control board (ECB) manages the overall operation, including safety interlocks. If the switch is off, no voltage should flow to the spark module.

Symptoms:

The Frigidaire stove top burner is clicking continuously, even when the burner knob is in the off position. This can be noisy and potentially create a safety hazard.

Possible Causes:

Faulty surface element switch
Defective electronic control board (ECB)
Shorted wiring harness
Damaged spark module
Moisture or debris on the igniter

Solution:

1

Disconnect power to the range at the breaker panel.
2

Remove the burner grate and surface burner to access the igniter and wiring. A 1/4-inch nut driver may be required.
3

Inspect the igniter for visible damage or debris. Clean with a dry cloth if necessary.
4

Use a multimeter to test the surface element switch for continuity in the off position. It should have no continuity. A reading indicates a faulty switch that needs replacement.
5

Check the wiring harness for any signs of shorts or damage. Repair or replace as needed. Common tools include wire strippers and electrical tape.
6

If the switch and wiring are good, the electronic control board (ECB) may be faulty. It is a complex component and may require licensed technician replacement. Consult the wiring diagram inside the range for proper connections.
7

Test the spark module. If it’s constantly sending voltage, it needs replacement. Expect around 120V AC when the burner switch is on. Use a multimeter to check voltage.

Safety Warning:

Disconnect power to the appliance at the breaker panel before performing any repairs. Lock Out, Tag Out (LOTO) procedures must be followed. High voltage is present in the appliance, and failure to disconnect power can result in serious injury or death.

Prevention:

Regularly clean the stove top surface to prevent debris buildup around the burners and igniters. Avoid spilling liquids onto the stove top, which can damage the electrical components. Use a non-abrasive cleaner.

Expert Tip:

Some Frigidaire ranges have a diagnostic mode. To access it, simultaneously press and hold the Bake and Broil buttons for 3 seconds. This may show error codes related to the burner circuits.

Frequently Asked Questions

•How do I test the surface element switch with a multimeter?

Disconnect power to the range. Remove the switch from the control panel. Set your multimeter to the continuity setting. Place the probes on the terminals of the switch. In the off position, there should be no continuity (open circuit). In the on position, there should be continuity (closed circuit).

•Where can I find replacement parts for my Frigidaire range?

You can find replacement parts at appliance parts retailers, both online and in local stores. Be sure to have your range's model number handy to ensure you get the correct parts.

•What is the typical voltage for the igniter circuit?

The igniter circuit typically operates at 120V AC. This voltage is supplied to the spark module when the burner switch is turned on.

Frigidaire Stove Top Burner Clicking When Off: Troubleshooting Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I test the surface element switch with a multimeter?

•Where can I find replacement parts for my Frigidaire range?

•What is the typical voltage for the igniter circuit?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: