Amana Washer Error Code F0E3: Troubleshooting and Repair... | appliancefaults.com

Technical Background:

error code F0E3 indicates that the Main Control Unit (MCU) has detected an excessive imbalance during the wash or spin cycle. The MCU monitors the load sensor and drum speed to determine if an imbalance condition exists. The MCU sends a 5V DC signal to the load sensor, and interprets the returning voltage to determine load size and balance.

Symptoms:

The Amana washer displays error code F0E3 during the wash cycle. The washer may stop mid-cycle, or the drum may spin erratically.

Possible Causes:

Excessive load size
Uneven distribution of laundry
Failed or worn suspension components (springs, struts)
Defective or miscalibrated load sensor
Main Control Unit (MCU) failure
Foreign object interfering with drum rotation

Solution:

1

Unplug the washer from the outlet.
2

Open the washer lid and manually redistribute the laundry to ensure an even distribution.
3

Inspect the suspension components (springs and struts) for signs of damage or wear. Replace any damaged components.
4

Check the load sensor wiring and connections to the MCU. Repair or replace any damaged wiring.
5

Use a multimeter to check the voltage to the load sensor from the MCU. Verify the voltage is within the manufacturer's specifications (typically 5V DC).
6

If the suspension and sensor are good, replace the Main Control Unit (MCU).
7

Plug the washer back into the outlet and run a calibration cycle per the service manual to reset the sensor.

Safety Warning:

Disconnect power to the appliance before performing any repairs. High voltage is present when the appliance is plugged in. Follow Lock Out/Tag Out (LOTO) procedures.

Prevention:

Avoid overloading the washer. Distribute laundry evenly in the drum. Regularly inspect the suspension components for signs of wear. Use HE (High Efficiency) detergent.

Expert Tip:

On some Amana models, entering service mode can provide detailed error logs and diagnostic information. Refer to the service manual for the specific button combination to enter service mode.

Frequently Asked Questions

•How do I access the service mode on this Amana washer?

The specific button sequence for entering service mode varies by model. Consult the Amana service manual for your specific model number. Common sequences involve pressing combinations of the cycle select and start buttons.

•Where is the load sensor located, and how do I test it with a multimeter?

The load sensor is typically located near the base of the washer, often attached to the suspension frame. With the unit unplugged, use a multimeter set to ohms to check the resistance across the sensor terminals. Compare the reading to the manufacturer's specifications in the service manual.

•What are the signs of a failing Main Control Unit (MCU)?

Symptoms of a failing MCU can include intermittent error codes, failure to start or complete cycles, and incorrect voltage outputs to various components. However, always rule out other potential causes before replacing the MCU, as it is a costly component.

Amana Washer Error Code F0E3: Troubleshooting and Repair Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I access the service mode on this Amana washer?

•Where is the load sensor located, and how do I test it with a multimeter?

•What are the signs of a failing Main Control Unit (MCU)?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: