Amana Washer Error Code F0E1: Load Detected During Water... | appliancefaults.com

Technical Background:

The washer's Main Control Unit (MCU) uses the pressure sensor to determine the water level and the presence of a load. The pressure sensor detects pressure changes in the tub, which are converted into a voltage signal that the MCU interprets. An incorrect signal can trigger the F0E1 error.

Symptoms:

The Amana washer displays error code F0E1, and the wash cycle may not start or may stop mid-cycle. The machine seems to think there's a load present even when the tub is empty.

Possible Causes:

Over suds condition interfering with load sensing.
Faulty pressure sensor (also known as a pressure transducer or water level sensor).
Wiring harness damage between the pressure sensor and the main control board.
Defective main control board (MCU).
Obstruction in the pressure hose to the tub.

Solution:

1

Unplug the washer from the 120V AC outlet or turn off the breaker.
2

Locate and inspect the pressure sensor. It's usually connected to the tub with a rubber hose. Check the hose for kinks, clogs, or damage.
3

Disconnect the pressure sensor and use a multimeter to check its resistance. Refer to the tech sheet for the correct resistance range. Expect a few thousand ohms.
4

Inspect the wiring harness connecting the pressure sensor to the main control board for any signs of damage (cuts, frayed wires).
5

Check the voltage to the pressure sensor from the main control board with your multimeter while the washer is attempting to fill. Look for approximately 5V DC.
6

If the wiring and pressure sensor appear good, the main control board may be faulty. Consider replacement.
7

After repairs, run a calibration cycle to properly set the pressure sensor range.

Safety Warning:

Always disconnect power to the appliance before performing any repairs. Lock Out/Tag Out (LOTO) procedures should be followed. Be aware of capacitors that may hold a charge even after power is disconnected. High voltage components are present inside the washer.

Prevention:

Use only HE (High Efficiency) detergent in the correct amount. Periodically check the pressure hose for any signs of wear or blockage. Avoid overloading the washer.

Expert Tip:

Access the diagnostic mode by pressing and holding the Start/Pause button for 3 seconds, then rotating the cycle selector knob rapidly clockwise three clicks, then counter-clockwise one click, and clockwise one click. This allows you to run diagnostic tests and clear error codes.

Frequently Asked Questions

•Where is the pressure sensor located on my Amana washer?

The pressure sensor is typically located near the bottom of the outer tub, inside the washer's cabinet. It is connected to the tub with a small rubber hose.

•What resistance value should I expect when testing the pressure sensor with a multimeter?

Refer to the Amana washer's service manual or tech sheet for the specific resistance range. A typical range might be between 2,000 and 5,000 ohms at room temperature, but this can vary by model.

•How do I perform a calibration cycle on my Amana washer after replacing the pressure sensor?

The calibration procedure varies by model. Refer to the service manual for the correct steps. Generally, it involves entering service mode and selecting a calibration routine that automatically adjusts the pressure sensor's readings.

Amana Washer Error Code F0E1: Load Detected During Water Wash Troubleshooting

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•Where is the pressure sensor located on my Amana washer?

•What resistance value should I expect when testing the pressure sensor with a multimeter?

•How do I perform a calibration cycle on my Amana washer after replacing the pressure sensor?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: