Amana Refrigerator Ice Maker Arm Down: No Ice... | appliancefaults.com

Technical Background:

The ice maker operates via a series of timed events controlled by a module. When the ice maker arm is down, it signals the module to initiate the ice-making cycle. This involves filling the ice mold with water through the water inlet valve, freezing the water, and ejecting the ice cubes. The module relies on a thermostat to determine when the water is frozen and ready for ejection. Voltage paths from the MCU must remain stable.

Symptoms:

The ice maker arm is in the down position (indicating it should be making ice), but no ice is being produced. The refrigerator is cooling properly.

Possible Causes:

Water supply line blockage or low water pressure.
Ice maker module failure.
Faulty water inlet valve.
Ice maker thermostat malfunction.
Frozen fill tube.

Solution:

1

Check the water supply line to the refrigerator. Ensure it is not kinked or blocked. Verify water pressure is at least 20 PSI.
2

Inspect the water inlet valve. Use a multimeter to check for continuity when the ice maker calls for water (approx. 120V AC should be present during the fill cycle). Replace if faulty.
3

Examine the ice maker module. Look for any visible damage, such as cracks or broken parts. Test the thermostat using a multimeter; it should show continuity when cold (below 15°F).
4

Check the fill tube for ice blockage. Use a hair dryer or steamer to carefully thaw any ice buildup. A turkey baster filled with warm water can also work.
5

If the above steps don't resolve the issue, consider replacing the ice maker module. These are often available as complete assemblies.
6

After repairs, allow 24 hours for the ice maker to begin producing ice. Monitor ice production over the next few days.

Safety Warning:

Always disconnect power to the refrigerator at the breaker panel before performing any repairs. Use Lock-Out Tag-Out (LOTO) procedures. The refrigerator contains 120V AC components.

Prevention:

Replace the refrigerator's water filter every 6 months to prevent mineral buildup in the water line and ice maker. Occasionally inspect the fill tube for ice buildup and thaw as needed. Clean the ice bin regularly to prevent ice clumping.

Expert Tip:

Many Amana refrigerators have a diagnostic mode. Typically, pressing and holding certain buttons on the control panel (consult your user manual) will initiate a self-test of the ice maker and other components.

Follow-up Questions:

Frequently Asked Questions

•How do I access the ice maker module in my Amana refrigerator?

Typically, the ice maker module is located in the freezer compartment. You may need to remove the ice bin and any surrounding panels to access it. Refer to your refrigerator's service manual for specific instructions.

•What is the correct voltage for the water inlet valve?

The water inlet valve typically operates on 120V AC. You should measure this voltage when the ice maker is calling for water during its fill cycle.

•How often should I replace the water filter in my Amana refrigerator?

It is recommended to replace the water filter every 6 months, or sooner if you notice a decrease in water flow or ice quality.

Amana Refrigerator Ice Maker Arm Down: No Ice Troubleshooting

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I access the ice maker module in my Amana refrigerator?

•What is the correct voltage for the water inlet valve?

•How often should I replace the water filter in my Amana refrigerator?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: