Amana Dryer Felt Seal Worn and Catching Clothes: Repair... | appliancefaults.com

Technical Background:

The felt seal prevents clothes from slipping between the drum and the dryer cabinet. A worn seal creates a gap allowing items to get caught, causing damage to clothing or the dryer itself. Proper drum rotation and airflow depend on a properly sealed drum.

Symptoms:

The homeowner reports that clothes are getting caught in a gap inside the dryer drum, and they observe the felt seal is worn or torn.

Possible Causes:

Worn or degraded felt material.
Improper system of the felt seal.
Excessive lint build-up behind the seal.
Mechanical damage from foreign objects (buttons, zippers).
Dryer drum misalignment causing uneven wear.

Solution:

1

Disconnect power to the dryer at the breaker panel. Verify 0V AC at the dryer receptacle with a multimeter.
2

Open the dryer door and locate the worn felt seal. Typically found around the drum baffle or front panel.
3

Remove the dryer front panel (usually requires a 1/4-inch nut driver). Disconnect any wiring harnesses attached to the front panel.
4

Carefully detach the old felt seal. Note the orientation for proper system of the new seal.
5

Clean the area where the new seal will be installed, removing any old adhesive or lint build-up.
6

Apply adhesive (if required) to the new felt seal and carefully position it around the drum, ensuring a snug fit.
7

Reassemble the dryer, reconnecting all wiring harnesses and securing the front panel with screws.

Safety Warning:

Lock Out/Tag Out (LOTO) the dryer at the breaker panel before any disassembly. High voltage is present inside the dryer; only qualified technicians should perform repairs.

Prevention:

Regularly clean the lint trap after each use. Inspect the felt seal periodically for signs of wear or damage. Avoid overloading the dryer with excessive amounts of clothing.

Expert Tip:

Use a heat-resistant silicone adhesive to secure the new felt seal for a longer-lasting repair. Some models have a service mode that allows for diagnostic testing; consult the technical service manual for specific instructions.

Frequently Asked Questions

•What type of adhesive should I use for the felt seal?

Use a high-temperature silicone adhesive designed for dryer applications. This will withstand the heat and prevent the seal from detaching.

•How do I properly align the dryer drum?

Check the drum rollers and support brackets for wear or damage. Replace any worn parts. Adjust the leveling feet to ensure the dryer is level. Slight misalignment can exacerbate seal wear.

•Where can I find the correct replacement felt seal for my Amana dryer model?

Locate the model number of your dryer (usually inside the door). Use this number to order the correct felt seal from a reputable appliance parts supplier. Generic seals may not fit properly.

Amana Dryer Felt Seal Worn and Catching Clothes: Repair Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•What type of adhesive should I use for the felt seal?

•How do I properly align the dryer drum?

•Where can I find the correct replacement felt seal for my Amana dryer model?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: