Admiral Washing Machine Error Code oL: Oversized Load... | appliancefaults.com

Technical Background:

The 'oL' error code indicates that the washing machine's MCU has detected an excessive load weight or an imbalance during the spin cycle. The MCU monitors the motor current and load sensor data to determine if the load is within acceptable limits. Voltage paths are monitored on the MCU.

Symptoms:

The washing machine displays the 'oL' error code on the control panel, often during or after the spin cycle. The machine may stop mid-cycle, and the basket might be noticeably overloaded with laundry.

Possible Causes:

Overloaded wash basket exceeding weight capacity.
Load imbalance during spin cycle.
Faulty load sensing system.
Defective motor control unit (MCU).
Wiring harness issue between the MCU and load sensor.

Solution:

1

Unplug the washing machine from the 120V AC outlet.
2

Manually redistribute the load inside the wash basket to ensure even distribution.
3

Inspect the suspension rods and springs for damage or wear. Replace if necessary.
4

Check the wiring harness between the motor control unit (MCU) and the load sensor for loose connections or damaged wires. Repair or replace as needed.
5

Disconnect and reconnect the load sensor connector on the MCU to ensure proper contact.
6

If the error persists, replace the load sensor. Use a multimeter to verify resistance is within specified range (typically between 5-10 kOhms).
7

As a last resort, replace the MCU. Ensure correct part number is used.

Safety Warning:

Disconnect power to the appliance at the breaker panel before performing any repairs. Use proper Lock Out Tag Out (LOTO) procedures. High voltage components are present; exercise caution when working near the MCU.

Prevention:

Avoid overloading the washing machine by adhering to the manufacturer's recommended load capacity. Regularly inspect suspension components for wear. Ensure proper leveling of the washing machine.

Expert Tip:

Some Admiral washing machines have a service mode. To enter service mode, simultaneously press and hold the 'Start/Pause' and 'Cycle Select' buttons for 3 seconds. This may allow for error code clearing and advanced diagnostics.

Frequently Asked Questions

•How do I determine the maximum load capacity of my Admiral washing machine?

Refer to the user manual or the model number sticker located on the washing machine. The load capacity is usually specified in pounds.

•Where is the load sensor located in my Admiral washing machine, and how do I access it?

The load sensor is typically located near the motor or suspension system. You may need to remove the front or rear panel of the washing machine to access it. Refer to the service manual for specific instructions.

•What is the proper resistance range for the load sensor, and how do I test it with a multimeter?

The proper resistance range for the load sensor is typically between 5-10 kOhms. Disconnect the sensor and set your multimeter to the resistance (Ohms) setting. Connect the multimeter probes to the sensor terminals and measure the resistance. Compare the reading to the specified range.

Admiral Washing Machine Error Code oL: Oversized Load Troubleshooting Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I determine the maximum load capacity of my Admiral washing machine?

•Where is the load sensor located in my Admiral washing machine, and how do I access it?

•What is the proper resistance range for the load sensor, and how do I test it with a multimeter?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: