Admiral Washer Sensing Light Flashing: Won't Fill with... | appliancefaults.com

Technical Background:

The Main Control Unit (MCU) monitors various sensors (water level, lid switch, etc.) to control the water filling process. A flashing sensing light usually indicates that the MCU is receiving conflicting or missing input from one of these sensors. The MCU applies 120V AC to the water inlet valve based on sensor inputs.

Symptoms:

The Admiral washer's sensing light is flashing, and the washer will not fill with water. The washer may also be unresponsive to start or other control inputs.

Possible Causes:

Faulty water inlet valve
Blocked water supply hose or inlet screens
Defective pressure switch
Malfunctioning lid switch
Low water pressure
Defective control board (MCU)

Solution:

1

Unplug the washer from the 120V AC outlet. Turn off the water supply to the washer.
2

Inspect the water supply hoses for kinks or obstructions. Remove the hoses and clean the inlet screens using a small brush.
3

Use a multimeter to test the water inlet valve solenoid. Set the meter to measure Ohms. A typical reading should be between 500 and 1500 Ohms. Replace if open or shorted.
4

Verify water pressure at the faucet using a pressure gauge. Minimum pressure should be 20 PSI. If low, investigate plumbing issues.
5

Test the lid switch for continuity using a multimeter. The switch should be closed (continuity) when the lid is closed. Replace if faulty.
6

Locate the pressure switch and its hose. Check the hose for clogs or leaks. Clean or replace the hose as needed.
7

As a last resort, replace the control board. This should be done only after verifying all other components are functioning correctly.

Safety Warning:

Always disconnect the appliance from the power supply (LOTO - Lock Out Tag Out) before performing any repairs. Be aware of potentially live 120V AC circuits when testing electrical components.

Prevention:

Regularly clean the water inlet screens to prevent clogs. Periodically inspect the water supply hoses for wear and tear. Avoid overloading the washer, as this can strain the components.

Expert Tip:

On some Admiral models, entering service mode may provide error codes that further pinpoint the problem. Try pressing and holding the Start/Pause and Power buttons simultaneously for 5 seconds to enter service mode.

Frequently Asked Questions

•What is the correct Ohm reading for the water inlet valve on my specific Admiral washer model?

Refer to the service manual for your specific Admiral washer model. The correct Ohm reading can vary slightly depending on the model.

•How do I access the control board on my Admiral washer to inspect it for damage?

Typically, the control board is located behind the control panel. You may need to remove screws or clips to access it. Be extremely careful when handling the control board to avoid static discharge.

•Where can I find a replacement water inlet valve or control board for my Admiral washer?

You can purchase replacement parts from appliance parts retailers, both online and in brick-and-mortar stores. Be sure to have your washer's model number handy to ensure you get the correct part.

Admiral Washer Sensing Light Flashing: Won't Fill with Water Troubleshooting

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•What is the correct Ohm reading for the water inlet valve on my specific Admiral washer model?

•How do I access the control board on my Admiral washer to inspect it for damage?

•Where can I find a replacement water inlet valve or control board for my Admiral washer?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: