Admiral Washer Error Code Out of Bal: Unbalanced Load... | appliancefaults.com

Technical Background:

Modern washing machines use a complex system to detect imbalances during the spin cycle. The Main Control Unit (MCU) monitors signals from the load sensor or suspension system. If an imbalance is detected, the MCU halts the spin cycle to prevent damage. Voltage paths are crucial for proper sensor operation and relay activation.

Symptoms:

The washer stops mid-cycle and displays an "Out of Bal" or similar error code. The drum may be visibly tilted or vibrating excessively. The cycle may not complete, leaving clothes wet.

Possible Causes:

Unevenly distributed laundry load.
Worn or damaged suspension rods.
Defective load sensor or imbalance detection system.
Washer not level.
Failed motor control board relay.

Solution:

1

Redistribute the load inside the washer drum, ensuring items aren't bunched on one side.
2

Check the washer's leveling. Use a bubble level and adjust the feet until the washer is perfectly level. Secure the leveling feet lock nuts.
3

Inspect the suspension rods for wear or damage. Replace if necessary. These are typically accessed by removing the top panel of the washer.
4

Examine the wire harness connecting the load sensor to the main control board. Look for loose connections or damaged wires. Use a multimeter to test continuity.
5

Test the motor control board relays using a multimeter. Refer to the washer's wiring diagram to identify the correct relays. Look for 120V AC at the relay coil during the spin cycle.
6

As a last resort, replace the motor control board.

Safety Warning:

Always disconnect power to the washer at the breaker panel before performing any repairs. Use caution when working with electrical components. 120V AC is present.

Prevention:

• Avoid overloading the washer. Follow the manufacturer's guidelines for load size.
• Distribute items evenly in the drum.
• Periodically check the washer's leveling.
• Inspect suspension rods annually for wear.

Expert Tip:

Some Admiral washers have a diagnostic mode. Try pressing and holding the start/pause button for 5 seconds to reset the error. This might clear the code temporarily.

Frequently Asked Questions

•How do I access the suspension rods on my Admiral washer?

Typically, you need to unplug the washer, shut off the water supply, and remove the top panel. This usually involves removing screws at the back of the unit. Once the top panel is off, you'll see the suspension rods connected to the tub.

•Where is the load sensor located?

The load sensor's location varies, but it's often integrated into the motor or the suspension system. Check the service manual or parts diagram for your specific model.

•What is the correct resistance reading for a good suspension rod?

Suspension rods don't have a resistance reading. You need to check for physical damage, such as cracks or excessive wear. Replace them if they appear weak or damaged.

Admiral Washer Error Code Out of Bal: Unbalanced Load Reset Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I access the suspension rods on my Admiral washer?

•Where is the load sensor located?

•What is the correct resistance reading for a good suspension rod?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: