Admiral Washer Lid Lock Light Flashing: Meaning and... | appliancefaults.com

Technical Background:

The MCU (Main Control Unit) monitors the lid switch and the lid lock solenoid. When a cycle is initiated, the MCU sends a signal to engage the lid lock. The MCU expects feedback from the lid switch confirming the lock is engaged. If this feedback is missing, or if the solenoid fails to activate, the MCU will display a fault code, often indicated by a flashing lid lock light.

Symptoms:

The homeowner reports the Admiral washing machine will not start, and the lid lock light is flashing continuously. The washer may attempt to start the cycle but then stops with the flashing light.

Possible Causes:

Lid switch malfunction
Control board failure
Wiring harness damage
Obstruction preventing lid lock engagement
Motor control unit (MCU) communication error
Door lock assembly failure

Solution:

1

Unplug the washer from the outlet.
2

Inspect the lid switch for damage or debris. Use a flashlight to examine the area.
3

Check the wiring harness connecting the lid switch to the control board. Look for frayed wires or loose connections.
4

Verify the lid lock mechanism is free from obstructions. Manually try to engage the lock.
5

Using a multimeter, test the lid switch for continuity when the lid is closed. You should see continuity when the lid is down.
6

Check the voltage to the lid lock solenoid. Typically, you should measure 120V AC when the washer is in the spin cycle.
7

If the above steps don't resolve the issue, suspect a faulty control board. Replacement is typically required.

Safety Warning:

Always disconnect power to the appliance before performing any repairs. High voltage is present within the appliance. Follow Lock Out/Tag Out (LOTO) procedures to ensure the washer cannot be accidentally powered on during repairs.

Prevention:

Avoid overloading the washer. Periodically clean the area around the lid lock to prevent debris buildup. Use the correct type and amount of detergent.

Expert Tip:

Some Admiral washers have a service mode that can display error codes. To enter service mode, simultaneously press and hold the Start/Pause and Cycle Select buttons for 3 seconds. The error code will be displayed on the control panel. Refer to the service manual for code definitions.

Frequently Asked Questions

•How do I locate the lid switch on my Admiral washer?

The lid switch is typically located on the washer frame near the lid hinge. It is often a small plastic component with wires connected to it. Follow the wires coming from the lid lock assembly, and it will lead you to the lid switch.

•What voltage should I expect to see at the lid lock solenoid when the washer is trying to spin?

You should expect to see approximately 120V AC at the lid lock solenoid when the washer is attempting to spin. Use a multimeter to verify the voltage. If there is no voltage, the control board may be faulty.

•If the lid switch tests good for continuity, what should I check next?

If the lid switch has continuity when the lid is closed, check the wiring harness between the lid switch and the control board for any breaks or loose connections. Also, make sure the connector is securely plugged into the control board. If the wiring is good, the control board may be faulty and not sending the signal properly.

Admiral Washer Lid Lock Light Flashing: Meaning and Reset Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I locate the lid switch on my Admiral washer?

•What voltage should I expect to see at the lid lock solenoid when the washer is trying to spin?

•If the lid switch tests good for continuity, what should I check next?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: