Admiral Washer Error Code F9E1: Long Drain Time... | appliancefaults.com

Technical Background:

The MCU (Main Control Unit) monitors the water level and drain time. The pressure sensor provides feedback to the MCU regarding the water level. If the MCU detects that the drain time exceeds a programmed limit, it triggers the F9E1 error code. The MCU controls the drain pump by sending 120V AC to the pump motor.

Symptoms:

The washer displays an F9E1 error code during or after the drain cycle. The washer may take significantly longer than usual to drain, or it may not drain completely, leaving clothes soaked. The user may hear unusual noises coming from the drain pump area.

Possible Causes:

Blocked drain pump filter
Kinked or obstructed drain hose
Faulty drain pump
Clogged standpipe or house drain
Defective pressure sensor
MCU malfunction

Solution:

1

Unplug the washer from the 120V AC outlet. Ensure the breaker is off.
2

Access the drain pump filter, typically located behind a front access panel secured with screws. Use a 1/4-inch nut driver to remove the screws.
3

Remove and clean the drain pump filter. Inspect for small objects like coins or lint.
4

Disconnect the drain hose from both the washer and the standpipe. Inspect for kinks, clogs, or damage.
5

Verify the drain pump operation by applying 120V AC to the pump motor terminals. Observe if the pump runs smoothly. Replace if faulty.
6

Check the pressure sensor using a multimeter. Refer to the service manual for resistance values. Replace if out of specification.
7

If all components check out, the MCU may be the cause and require replacement. This may require dealer programming.

Safety Warning:

Disconnect power to the appliance at the breaker panel before performing any repairs. Use proper lockout/tagout (LOTO) procedures to prevent accidental energization. Be aware of potential electrical shock hazards when working with electrical components.

Prevention:

Regularly clean the drain pump filter every 3-6 months. Inspect the drain hose for kinks or damage annually. Avoid overloading the washer to prevent excessive lint buildup.

Expert Tip:

Some Admiral washers have a diagnostic mode that allows you to run individual component tests, including the drain pump. Refer to the service manual for the specific key sequence to enter diagnostic mode.

Frequently Asked Questions

•What is the correct resistance range for the pressure sensor on this Admiral washer?

The resistance range for the pressure sensor varies depending on the model. Consult the specific service manual for your washer, or check the wiring diagram usually located inside the control panel. Typical values are between 1k and 5k ohms at rest.

•How do I access the diagnostic mode on this Admiral washer to test the drain pump?

Accessing the diagnostic mode varies by model. Common sequences involve pressing a combination of buttons on the control panel in a specific order, such as 'Start/Pause', 'Temp', 'Soil Level', 'Start/Pause'. Consult the service manual or search online using your specific model number for the correct sequence.

•If the drain pump is running, but the washer is still not draining, what else could be the problem?

If the drain pump is running, but the washer isn't draining, check for a blockage in the drain hose where it connects to the tub. Also, verify the standpipe is not clogged and is properly vented. A partial blockage can restrict water flow even with a functional pump.

Admiral Washer Error Code F9E1: Long Drain Time Troubleshooting

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•What is the correct resistance range for the pressure sensor on this Admiral washer?

•How do I access the diagnostic mode on this Admiral washer to test the drain pump?

•If the drain pump is running, but the washer is still not draining, what else could be the problem?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: