Admiral Washer Error Code F1E2: Motor Control Board... | appliancefaults.com

Technical Background:

The F1E2 error code indicates a fault within the motor control board (MCU) circuit. This board regulates power to the motor and communicates with the main control board. The MCU monitors voltage and current levels, and a discrepancy triggers the error. Voltage paths from the main control board and to the motor are critical.

Symptoms:

The Admiral washer displays an F1E2 error code on the control panel and will not start or operate correctly. The motor may not run, or the washer may stop mid-cycle.

Possible Causes:

Faulty motor control board (MCU)
Wiring harness issue between MCU and motor
Defective motor
Voltage supply problems to the MCU
Loose connections on the MCU or motor

Solution:

1

Disconnect power to the washer at the breaker panel.
2

Locate the motor control board (MCU), typically behind the control panel or in the base of the unit.
3

Inspect wiring harness connections to the MCU and motor for looseness or damage.
4

Using a multimeter, check the voltage supply to the MCU. You should see approximately 120V AC.
5

Check the motor windings for continuity. An open winding indicates a faulty motor. Resistance should be a few ohms.
6

If wiring and motor test OK, replace the motor control board (MCU).
7

Reconnect power and test the washer.

Safety Warning:

Always disconnect power to the appliance at the breaker panel before attempting any repairs. Use Lock-Out/Tag-Out (LOTO) procedures to prevent accidental power restoration. High voltage is present within the appliance.

Prevention:

Periodically inspect wiring connections for tightness. Avoid overloading the washer. Use the correct type and amount of detergent. Clean the drain pump filter regularly.

Expert Tip:

Some Admiral washers have a service mode. Consult the service manual to access it. Running a diagnostic cycle can help pinpoint the source of the F1E2 error by isolating the motor control system.

Frequently Asked Questions

•What is the resistance value I should expect on the motor windings?

The motor winding resistance should typically be between 3 to 8 ohms. An open circuit (infinite resistance) indicates a faulty motor.

•How do I access the service mode on my Admiral washer?

Service mode access varies by model. Typically, it involves pressing a specific sequence of buttons on the control panel. Consult the technical sheet located inside the washer cabinet or the service manual for your specific model.

•Where is the motor control board (MCU) typically located in an Admiral washer?

The MCU is commonly located behind the control panel or in the base of the washer, near the motor. Refer to your specific model's parts diagram for the exact location.

Admiral Washer Error Code F1E2: Motor Control Board Fault Troubleshooting

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•What is the resistance value I should expect on the motor windings?

•How do I access the service mode on my Admiral washer?

•Where is the motor control board (MCU) typically located in an Admiral washer?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: