Admiral Washing Machine Error Code dL: Lid Lock... | appliancefaults.com

Technical Background:

The dL error code indicates a problem with the lid lock mechanism. The MCU monitors the lid lock switch to ensure the lid is securely closed before initiating or continuing the wash cycle. The lid lock system typically utilizes a solenoid or motor to engage the lock, and a switch to provide feedback to the MCU.

Symptoms:

The washing machine displays the error code dL and the lid will not lock. The washer may not start the wash cycle, or it may stop mid-cycle.

Possible Causes:

Faulty lid lock switch.
Wiring harness issue between the MCU and lid lock.
Defective MCU (Main Control Unit).
Obstruction preventing the lid from fully closing.
Lid switch actuator misalignment.

Solution:

1

Unplug the washing machine from the outlet.
2

Inspect the lid lock assembly for physical damage or obstructions.
3

Check the wiring harness and connectors leading to the lid lock for loose connections or damaged wires. Repair or replace as needed.
4

Use a multimeter to test the lid lock switch for continuity when the lid is closed. Refer to the wiring diagram for correct pinouts. Replace the lid lock if it fails the continuity test.
5

If the wiring and lid lock are good, suspect the MCU. Check for 120V AC at the appropriate terminals on the MCU when the lock cycle is initiated.
6

If no voltage is present, the MCU is faulty and needs replacement.
7

Plug the washing machine back in and test the operation. If the error persists, further diagnosis may be needed.

Safety Warning:

Disconnect power to the appliance before performing any repairs. High voltage is present inside the appliance. Use proper lockout/tagout (LOTO) procedures.

Prevention:

Avoid slamming the lid shut, as this can damage the lid lock mechanism. Periodically inspect the lid lock area for debris and clean as needed.

Expert Tip:

Some Admiral washers have a service mode that allows you to test the lid lock function. Consult the service manual for the specific model to access service mode and run diagnostics.

Frequently Asked Questions

•Where can I find the wiring diagram for my Admiral washing machine?

The wiring diagram is usually located inside the control panel of the washing machine, often attached to the back of the console or inside the machine's cabinet. It may also be available online through the manufacturer's website or appliance parts suppliers. You'll need the model number of your washing machine to find the correct diagram.

•How do I know if my MCU is faulty?

If you've ruled out the lid lock switch and wiring as the cause of the dL error, and you've verified that the MCU is not sending voltage to the lid lock when it should, then the MCU is likely faulty. A faulty MCU can also exhibit other symptoms such as erratic behavior, failure to respond to commands, or other error codes.

•What is the part number for the replacement lid lock assembly?

You'll need the model number of your washing machine to determine the correct part number for the lid lock assembly. You can find the model number on a sticker usually located on the cabinet near the lid opening or on the back of the machine. Once you have the model number, you can search for the part number on appliance parts websites.

Admiral Washing Machine Error Code dL: Lid Lock Troubleshooting & Reset Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•Where can I find the wiring diagram for my Admiral washing machine?

•How do I know if my MCU is faulty?

•What is the part number for the replacement lid lock assembly?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: