Frequently Asked Questions
•How do I access the drain pump on my Admiral washer?
Typically, the drain pump is located behind a lower access panel on the front of the washing machine. You'll need to remove a few screws (usually with a 1/4-inch nut driver) to access it. Be prepared for some water to spill out when you remove the pump.
•What is the proper tension for the drive belt on my Admiral washer?
The drive belt should have enough tension to prevent slippage during the spin cycle, but not so much that it strains the motor or pulleys. A good rule of thumb is that you should be able to deflect the belt about 1/2 inch to 3/4 inch at its midpoint between the pulleys. Refer to the model-specific service manual for exact specs.
•How do I test the water level sensor with a multimeter?
First, disconnect the sensor's connector. Set your multimeter to measure DC voltage. With the connector disconnected, check for a 5V DC reference voltage across the appropriate pins (refer to the wiring diagram). If the voltage is present, reconnect the sensor and measure the voltage output as you slowly fill the tub with water. The voltage should change proportionally to the water level. A lack of change indicates a faulty sensor.