Admiral Washer Clicking During Spin Ramp Up:... | appliancefaults.com

Technical Background:

The MCU (Microcontroller Unit) controls the motor speed via a triac circuit. The motor receives variable voltage (typically 0-120V AC) based on the MCU’s signal, ramping up the spin speed. A clicking sound could indicate a mechanical issue related to the motor drive system or a foreign object interfering with rotation.

Symptoms:

The Admiral washing machine is making a clicking sound during the spin cycle ramp-up. The clicking noise may be intermittent or consistent. The spin cycle may not reach full speed.

Possible Causes:

Worn or damaged drive belt
Foreign object lodged in the drain pump
Loose or broken motor coupling
Defective motor bearings
Worn clutch assembly
Damaged tub bearing

Solution:

1

Unplug the washing machine from the 120V AC outlet.
2

Access the drive motor and belt area by removing the rear access panel using a 1/4-inch nut driver.
3

Inspect the drive belt for signs of wear, cracks, or damage. Replace if necessary.
4

Check the motor coupling for any looseness or breakage. Replace if needed.
5

Inspect the drain pump for foreign objects. Remove any obstructions.
6

Rotate the motor by hand. Listen for unusual noises which may indicate worn motor bearings. If noisy, replace the motor.
7

Check the tub bearing by trying to move the inner tub up and down. Excess play indicates bearing failure and requires licensed technician service or tub assembly replacement.

Safety Warning:

Always disconnect power (LOTO - Lock Out Tag Out) to the washing machine before performing any repairs. High voltage is present when the machine is plugged in. Use extreme caution.

Prevention:

Regularly inspect and clean the drain pump filter to prevent foreign objects from entering the pump. Avoid overloading the washing machine to prevent excessive stress on the drive components. Inspect the drive belt annually.

Expert Tip:

Some Admiral washers have a diagnostic mode. Press and hold the Start/Pause button for 3 seconds, then rapidly rotate the cycle selector knob three clicks clockwise, then one click counter-clockwise, then one click clockwise. This may reveal error codes related to the motor or drive system.

Frequently Asked Questions

•How do I remove the drain pump to check for obstructions?

After disconnecting power, typically the drain pump is accessible from the front or rear of the machine after removing an access panel. You may need a 5/16-inch socket to remove mounting screws. Disconnect the hoses and check for blockages.

•What type of drive belt does my Admiral washer use?

The belt type varies by model. Check the model number on the appliance and refer to the parts diagram or manufacturer's website for the correct replacement belt. Common types include V-belts and multi-rib belts.

•How do I test the motor windings?

Use a multimeter to check the resistance of the motor windings. Disconnect the motor wiring harness. There should be continuity between the windings. An open circuit indicates a failed winding. Refer to the service manual for specific resistance values.

Admiral Washer Clicking During Spin Ramp Up: Troubleshooting & Repair

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I remove the drain pump to check for obstructions?

•What type of drive belt does my Admiral washer use?

•How do I test the motor windings?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: