Frequently Asked Questions
•Where is the thermal fuse located on my Admiral dryer?
The thermal fuse is typically located on the blower housing, which is inside the dryer cabinet, usually near the exhaust vent. You'll need to remove the rear access panel to locate it. It's a small, white or black component with two wires connected to it.
•How do I test the thermistor with a multimeter?
First, disconnect the thermistor. Set your multimeter to the resistance (Ohms) setting. Place the multimeter probes on the thermistor terminals. You should get a resistance reading. The specific resistance value depends on the temperature of the thermistor. A service manual will provide the resistance value at room temperature. If the reading is significantly different or reads open (infinite resistance), replace the thermistor.
•What are the typical symptoms of a bad dryer motor?
Typical symptoms of a bad dryer motor include the dryer not starting at all, making unusual noises (humming, squealing), tripping the breaker, or running intermittently and then shutting off. Overheating can also point to a motor problem.