Admiral Dryer Felt Seal Worn: Clothes Catching -... | appliancefaults.com

Technical Background:

MCU logic and voltage paths.
While the felt seal itself isn't directly related to the MCU (Main Control Unit), a damaged seal can lead to increased lint buildup, potentially affecting thermistors or thermal fuses, which are monitored by the MCU for safety. Voltage paths aren't directly relevant to seal replacement but are important for diagnosing related electrical issues.

Symptoms:

US homeowner observations.
The dryer is catching clothes in the gap between the drum and the front panel. The felt seal appears worn and frayed, with visible gaps or tears. Excessive lint buildup is also noted around the seal.

Possible Causes:

Worn or damaged felt seal.
Improper dryer assembly.
Excessive lint buildup around the seal.
Dryer drum out of alignment.
Damaged or missing retaining clips for the seal.

Solution:

1

Disconnect power to the dryer at the breaker panel.
2

Open the dryer door and remove the lint filter.
3

Using a 1/4-inch nut driver, remove the screws securing the front panel of the dryer.
4

Carefully detach the front panel, noting the location of any wires connected to door switches. Document the wire connections with your cell phone before disconnection.
5

Inspect the felt seal for wear, tears, or detachment from the drum.
6

Remove the old felt seal and clean the area where the new seal will be installed using a putty knife.
7

Install the new felt seal, ensuring it is securely attached to the drum and front panel. Use manufacturer-approved high temp adhesive if necessary. Verify the drum rotates freely without catching on the new seal. Reassemble the dryer. Ensure the front panel sits flush. Test operation.

Safety Warning:

Always disconnect power to the dryer at the breaker panel before performing any repairs. High voltage is present within the dryer. Lock Out Tag Out (LOTO) procedures are recommended.

Prevention:

• Regularly clean the lint filter after each load.
• Inspect the felt seal every 6 months for wear and tear.
• Ensure proper dryer venting to prevent excessive lint buildup.

Expert Tip:

Use a heat gun (on low setting) to soften the old adhesive when removing the old felt seal. This makes removal easier and prevents damage to the dryer drum.

Frequently Asked Questions

•How do I properly align the dryer drum to ensure the new felt seal doesn't wear out prematurely?

Check the rollers and glides for wear. Replace them if necessary. Ensure the dryer is level using a level on the top surface. Adjust the leveling feet as needed.

•What type of adhesive should I use to attach the new felt seal?

Use a high-temperature adhesive specifically designed for dryer felt seals. Contact cement is a common choice, but always follow the manufacturer's recommendations.

•How often should I replace the felt seal?

The lifespan of a felt seal varies depending on usage. Inspect it every 6 months and replace it when you notice significant wear, tears, or gaps.

Admiral Dryer Felt Seal Worn: Clothes Catching - Troubleshooting Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I properly align the dryer drum to ensure the new felt seal doesn't wear out prematurely?

•What type of adhesive should I use to attach the new felt seal?

•How often should I replace the felt seal?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: