Amana Washer Error Code F1E2: Motor Control Board Fault... | appliancefaults.com

Technical Background:

The F1E2 error code on an Amana washer indicates a fault with the motor control board (MCU). The MCU is responsible for controlling the motor's speed and direction during the wash cycle. It receives signals from the main control board and uses this information to regulate the voltage and current supplied to the motor. The MCU monitors voltage levels and sends diagnostic data to the main control board.

Symptoms:

The washer displays error code F1E2 on the control panel. The washer may not start, or the motor may not run during the wash cycle. Intermittent operation might also occur.

Possible Causes:

Faulty motor control board (MCU)
Loose wiring connections to the MCU
Defective motor
Voltage supply issue to the MCU
Software glitch within the MCU
Damaged wire harness

Solution:

1

Unplug the washer from the 120V AC power outlet.
2

Access the motor control board (MCU), typically located behind the control panel or at the base of the washer.
3

Visually inspect the MCU for any signs of damage, such as burnt components or corrosion.
4

Check all wiring connections to the MCU, ensuring they are secure and free from corrosion. Use a multimeter to verify continuity of the wires.
5

Use a multimeter to test the voltage supply to the MCU. You should typically see 120V AC coming in and 5V DC or 12V DC to other components, depending on the specific circuit. Consult the wiring diagram.
6

If the voltage supply is good and the wiring is secure, replace the motor control board with a new, OEM-approved part.
7

After replacing the MCU, plug the washer back in and run a test cycle to verify that the error code is resolved.

Safety Warning:

Disconnect power to the appliance before attempting any repairs. Lock Out/Tag Out (LOTO) procedures should be followed to prevent accidental re-energization. High voltage is present in the appliance, exercise caution.

Prevention:

Regularly inspect the wiring connections to the motor and MCU. Avoid overloading the washer, as this can strain the motor and MCU. Use surge protectors to protect the washer from power surges.

Expert Tip:

Some Amana washers have a diagnostic mode. To access it, press and hold the Start/Pause button while simultaneously pressing another button (check the service manual for your specific model). This can provide more detailed error information and allow you to run diagnostic tests.

Frequently Asked Questions

•Where is the motor control board located on my Amana washer model?

The motor control board (MCU) is typically located behind the control panel or at the base of the washer cabinet. Refer to your washer's service manual for the exact location.

•How do I test the voltage supply to the motor control board?

Use a multimeter set to AC voltage to test the incoming voltage, typically 120V AC. Then, use a multimeter set to DC voltage to test the various DC voltage outputs, such as 5V DC or 12V DC, based on your schematic. Refer to the wiring diagram for specific test points.

•Where can I purchase a replacement motor control board for my Amana washer?

You can purchase a replacement motor control board from appliance parts retailers, both online and in brick-and-mortar stores. Ensure you purchase an OEM (Original Equipment Manufacturer) part that is specifically designed for your Amana washer model.

Amana Washer Error Code F1E2: Motor Control Board Fault Guide

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•Where is the motor control board located on my Amana washer model?

•How do I test the voltage supply to the motor control board?

•Where can I purchase a replacement motor control board for my Amana washer?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: