Admiral Washing Machine Error Code F5E4: Lid Cycle Fault... | appliancefaults.com

Technical Background:

The F5E4 error indicates that the machine control unit (MCU) is not receiving the expected signal from the lid switch during the wash cycle. The MCU monitors the voltage signal from the lid switch to verify the lid is closed. If the voltage signal is outside of the specified range (typically a loss of continuity indicating an open circuit), the F5E4 error is triggered.

Symptoms:

The washing machine displays error code F5E4 and will not start a wash cycle. The lid may or may not be locked. The machine may fill with water but then stop. The customer reports the washer stopped mid-cycle.

Possible Causes:

Faulty lid switch assembly
Wiring harness damage to the lid switch
Control board failure
Lid lock solenoid malfunction
Loose wiring connections at the switch or control board

Solution:

1

Disconnect power to the washing machine at the breaker panel.
2

Locate the lid switch assembly, usually under the top panel of the washer. Use a 1/4-inch nut driver to remove screws securing the top panel.
3

Inspect the wiring harness connected to the lid switch for any visible damage like cuts or frayed wires. Repair or replace as needed.
4

Use a multimeter to test the lid switch for continuity when the lid is closed. It should show continuity. If not, replace the lid switch.
5

Check the voltage at the lid switch connector with the washer attempting to start a cycle. You should see approximately 120V AC. If no voltage is present, the issue is likely with the control board or wiring.
6

Inspect the lid lock solenoid (if equipped) for proper operation. It should engage when the washer starts. Replace if faulty.
7

If all components test good, the main control board is likely the issue and will need replacement.

Safety Warning:

Always disconnect power to the appliance at the breaker panel before attempting any repairs. Lock Out / Tag Out (LOTO) procedures should be followed. The washing machine operates on 120V AC, which can cause serious injury or death.

Prevention:

Avoid slamming the washer lid, as this can damage the lid switch. Regularly inspect the wiring harness for signs of wear and tear. Ensure the washing machine is level to prevent excessive vibration, which can loosen connections.

Expert Tip:

Some Admiral washers have a diagnostic mode that can be accessed by pressing a specific sequence of buttons (consult the service manual). This mode can provide more detailed information about the error and allow you to test individual components.

Frequently Asked Questions

•What is the part number for the lid switch on this model?

The part number for the lid switch on this Admiral washing machine model is usually located on the switch itself. However, based on the model, a common replacement is W10834942. Always verify with your parts supplier.

•How do I access the diagnostic mode on this washer?

To access the diagnostic mode, typically you need to press a sequence of buttons within a short time frame. Common sequences are holding the START/PAUSE button for 3 seconds, or rotating the cycle selector quickly 3 clicks clockwise then 2 clicks counter-clockwise. Consult the service manual for the exact sequence specific to this model.

•Where is the main control board located?

The main control board is typically located behind the control panel at the top rear of the washing machine. You may need to remove the top panel and then the control panel to access it. Be careful to disconnect power before accessing and note the wiring connections.

Admiral Washing Machine Error Code F5E4: Lid Cycle Fault Troubleshooting

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•What is the part number for the lid switch on this model?

•How do I access the diagnostic mode on this washer?

•Where is the main control board located?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: