Admiral Top Load Washer: How to Manually Drain Water (No... | appliancefaults.com

Technical Background:

Admiral top load washers use an MCU (Microcontroller Unit) to control the various components, including the drain pump. The MCU sends a 120V AC signal to the drain pump motor based on the selected cycle and water level. A faulty drain pump or a blocked drain path can prevent the washer from draining. The MCU also monitors sensors and can trigger error codes if drainage problems are detected.

Symptoms:

The Admiral top load washer is full of water and will not drain after completing a wash cycle. The user is seeking a way to manually drain the water without the pump functioning.

Possible Causes:

Clogged drain hose
Kinked drain hose
Failed drain pump
Blocked drain pump filter
Air lock in the drain system

Solution:

1

Unplug the washer from the 120V AC outlet. LOTO.
2

Locate the drain hose at the back of the washer.
3

Disconnect the drain hose from the standpipe or drain connection.
4

Lower the drain hose to a level below the washer tub, directing it into a bucket or large container.
5

If water doesn't flow freely, check the drain hose for kinks or clogs. Clear any obstructions.
6

If the drain hose is clear, access the drain pump filter (usually located behind a small access panel at the front or bottom of the washer) and clean out any debris.
7

Once drained, reconnect the drain hose securely. Run a test cycle to confirm proper draining. If the washer still doesn't drain, test the voltage to the drain pump (120V AC when activated). If voltage is present, the pump is likely faulty and needs replacing.

Safety Warning:

Disconnect power (LOTO - Lock Out Tag Out) to the washer before performing any maintenance or repairs. Electrical shock hazard exists with 120V AC components. Never work on a washer while it is connected to power.

Prevention:

Regularly inspect and clean the drain pump filter (every 3-6 months) to prevent clogs. Avoid overloading the washer, as excessive lint can contribute to drain problems. Ensure the drain hose is free from kinks and is properly positioned in the standpipe.

Expert Tip:

Most Admiral washers have a diagnostic mode. Press and hold the start button, then rapidly rotate the cycle selector knob one click clockwise, then one click counter-clockwise, and then one click clockwise again. This should put the washer into diagnostic mode. Check the display for error codes related to the drain pump or water level sensor.

Frequently Asked Questions

•How do I access the drain pump filter on my Admiral top load washer?

The drain pump filter is typically located behind a small access panel at the front or bottom of the washer. You may need a flathead screwdriver to remove the panel. Refer to your owner's manual for the exact location.

•How do I test the drain pump for continuity?

After disconnecting power to the washer (LOTO), disconnect the wires from the drain pump motor. Use a multimeter set to ohms to check for continuity across the pump motor terminals. A reading of OL (open line) indicates a faulty pump.

•What voltage should I expect at the drain pump when it's supposed to be draining?

You should measure approximately 120V AC at the drain pump terminals when the washer is in the drain cycle. Use a multimeter to measure the voltage.

Admiral Top Load Washer: How to Manually Drain Water (No Pump)

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip:

Frequently Asked Questions

•How do I access the drain pump filter on my Admiral top load washer?

•How do I test the drain pump for continuity?

•What voltage should I expect at the drain pump when it's supposed to be draining?

Related questions

Technical Background:

Symptoms:

Possible Causes:

Solution:

Safety Warning:

Prevention:

Expert Tip: